PushGate | thiNcoderRT | MagnaMouse | Transparent | Light Bar | Flex-Rocker | Flex-Push | IPS | Rubber Protos
IN2TEC has been utilisiing moulded
elastomeric keymats as the actuator layer
for membrane switch circuits on both
flexi circuit and pcb based products for
more than 10 years. This system allows
the design to be used in a wide variety
of environments. IP67 sealing is a
relatively simple option using this
technology. The development of
elastomer based product design and an
innovative approach to a Single
push-button switch has resulted in a
patent application for a low profile
momentary action low current single
switch design . |
|
The market demand for simple push switch with optional back-lighting resulted in a unit which can be installed simply
and is able to be easily customised to suit the application. A significant benefit of this product range of mounting options
and legends all of which minimise the space requirement for the switch within the panel it sits. |
|
|
- COST
- The reduction of space and simple mounting options this integral construction means the product usually results an overall
reduction of installation costs.
- An example would be simply to insert the product to a flat surface with a single hole to allow interconnection.
- ENVIRONMENTAL
- The benefits of both silicone rubber and other thermo plastic elastomers allow this product to be sealed to the panel on
which it is mounted. Hard coated options are available where abrasion may be concern.
- INTERCONNECTION
- The adhesive technologies used provide a lead free product and a range of interconnection options.
- FLEXIBILITY
- This design can be customised and incorporated into a front panel solution. Alternatively it may be mounted as a stand
alone single unit.
- OPTIONS
- Single pole, illuminated custom legends.
-
- The Flexi Push switch has great flexibility, Applications in Military Computers, Operating theatre equipment (Steam
Sterilized), Greenhouse Climate Control Systems and Yacht Control Panels prove the switches ability to operate in a
number of harsh environments.
-
ELECTRICAL
- Power Resistance
- Silver printed track per track Max 0.5 Watts .2 Ohm/cm Typical non arcing
- Resistance per joint .3 Ohm/cm Typical
- Circuit Voltage 100 Volts Dependent on design
- Typical rating per switch 1 to 10mA
- Standard Maximum 100mA
- Switch Capacitance 10pF Typical
- Dielectric Volume
- Material Strength Resistivity
- Polyester 125kV/mm 10 GOhm.cm
- Polycarbonate 67kV/mm 100 MOhm.cm
- IP rating 54 to 67 Dependent on design
- Environment
- Operating temperature -30 to 120°C Subject to design
- Illumination Methods
- LED Indicator or full back-light
- Mechanical Typically .3 to .5mm + component height
- Stroke Typically 0.5 -1mm
- Note: The above data is approximate and for information only
|
|
Click here to view Flex-Push documents available for download. |