PushGate | thiNcoderRT | MagnaMouse | Transparent | Light Bar | Flex-Rocker | Flex-Push | IPS | Rubber Protos

  

IN2TEC has been utilisiing moulded elastomers in its  keymats as the actuator layer for membrane switch circuits  on both   flexi circuit and pcb based products for more than  10 years. This system allows the design to be used in a wide  variety of   environments. IP67 sealing is a relatively simple  option using this technology. The development of an  elastomer based light   diffuser and an innovative design  approach resulted in significant cost savings when compared  to standard light bars.   These can be incorporated into a  flexcircuit , front panel assembly or mounted as stand alone  products. The design allows   indication in high ambient light  conditions and can also provide low level back ground light  within a panel. The unit which   can be installed simply and is  able to be easily customised to suit serpentine applications.

  COST

  This design resulted from applying innovative approach to reduce component count and improve quality for light indicator.   The result was a simplified product at lower cost.

  ENVIRONMENTAL

  The benefits of both silicone rubber and other thermo plastic elastomers allow this product to be sealed to the panel on   which it is mounted. Illumination is normally provided using LED technology and a rubber light diffuser to avoid hot spots.

  INTERCONNECTION

  The adhesive technologies used provide a lead free product and a range of interconnection options.

  FLEXIBILITY

  This design can be customised and incorporated into a front panel solution. Alternatively it may be mounted as a stand   alone single unit.

  OPTIONS

  Serpentine form, range of led colours and brightness.

  ATM and Banking Machinery, Low voltage illumination.

ELECTRICAL   Volts Power Resistance   Supply 12 V as Standard .2 Ohm/cm Typical non arcing   Resistance per joint .3 Ohm/cm Typical   Circuit Voltage 12V Dependent on design   Typical rating per switch N/A   Standard Current 20mA/cm Typical   IP rating 54 to 67 Dependent on design   ENVIRONMENTAL   Operating temperature -30 to 65°C Subject to design   Illumination Methods   Green as std Indicator or full back-light LED colours   Light Output custom Led dependent   MECHANICAL   Typically Height 3-10mm ,length custom   Note: The above data is approximate and for information only   Click here to view Light Bar documents available for download.